Stulz C7000 - Page 29

29
Info
Type.............:1 (Unit room temp)
Store cycle......:15 Min
Number of values.:938
Youngest.........:11.08.2004 15:33:00
Eldest...........:01.08.2004 02:18:00
0001. 11.08.2004 15:33:00 Room temperature 22,9°C
0002. 11.08.2004 15:18:00 Room temperature 23,0°C
0003. 11.08.2004 15:03:00 Room temperature 23,1°C
log 1
log 1 1
log 1 2
log 1 72
log 1 15.05.2006
log 1 1 13
log 1 clear
© STULZ GmbH – all rights reserved EN/06.2019/G57
C7000 INSTRUCTIONS FOR A/C UNITS
for data logger 1 each
- displays adjustments, number of data and date
of recent and eldest value.
- displays the 20 recent values as follows.
- edits the 20 recent but one values (value 21 to
40 counting from the actual point of time).
- edits the eldest 20 values (value 1421 to
1440 counting from the actual point of time).
- edits all values of this day as far as stored.
- edits the values 1 to 13 counting from the
actual point of time.
- deletes all stored values.
The corresponding commands:
Zone
If the unit is assigned to a zone, in this window the values of the corresponding
zone are displayed. In the first line it is displayed if emergency operation for this
zone is activated. In the second line you see the sequencing cycle time. Then
the room temperature, the room humidity, the supply air temperature and the
supply air humidity of the zone are diisplayed.
If the determination of average values is disabled, these values correspond to
the measured unit values.
Statistics/Data logger
By the data logger you can save measured values or average values (zone data)
calculated by the controller and have them displayed in the shape of a graphi-
cal curve so as to show the time course of these values.
Values of two different sensors can be simultaneously recorded.
You set the lapse of time which will be displayed. Further parameters (type of
measured value and cycle) can be adjusted in the service menu.
You can choose among 5 different lapses of time: hour (adjusting this lapse
displays the recent 3 hours), day, week, month and year.
The time lapse is displayed in horizontal direction, a vertical dashed line marks
the actual time.
In the vertical direction the range of the measured value within the limit values
(if existant for this type of value) is displayed. Two exterior dashed lines mark
the limit values. An interior dotted line marks the set value, if existant.
The course of the measured value is displayed by a continuous line.
Note:
Before these values can be displayed, the recording must be activated in the
corresponding Config menu.
If the A/C unit is de-energized, the memories of both data loggers are deleted.
(The control however, can be switched off by the start/stop key without having
the data loggers deleted.)