Sumitomo CYCLO Service Manual

98
3. Transport
Common
8
DANGER
- Do not stand directly under a unit suspended by a crane or other lifting mechanism; otherwise, injury, or death may
result.
CAUTION
- Exercise ample care so as not to drop the unit.
When a hanging bolt or hole is provided, be sure to use it. After mounting a unit to a machine, do not hoist the entire
machine using the hanging bolt or hole; otherwise, personal injury or damage to the equipment and/ or lifting device
may result.
- Before hoisting, refer to the rating plate, crate, outline drawing, catalog, etc. for the weight of the unit. Never hoist a unit
that exceeds the rating of the crane or other mechanism being used to lift it; otherwise, personal injury or damage to the
equipment and/ or lifting device may result.
- When the products are lifted, use suitable lifting parts, and conrm which eye-bolts and nuts are not loose.
- Always drain oil lubricated models before mounting, moving, and transporting.
Moving with lubricating oil in the machine may cause oil to escape from the air vent, etc.

Sumitomo CYCLO Specifications

General

Control Method	PWM (Pulse Width Modulation)
Cooling Method	Forced air cooling
Protection Features	Overcurrent Protection, Overvoltage Protection, Overtemperature Protection, Short Circuit Protection
Operating Temperature	0°C to 40°C
Humidity	20% to 90% (non-condensing)
Dimensions	Varies by model
Weight	Varies depending on model (Consult specific datasheet)
Storage Temperature	-20°C to +60°C