Sumitomo CYCLO - Table of Contents; Introduction: How to Refer to the Maintenance Manual, Table of Contents

22
Introduction: How to Refer to the Maintenance Manual, Table of Contents
This maintenance manual is common for “gearmotors”, “reducers”, “CYCLO Drive for servo motor” and “the application products CYCLO
Drive with Torque Limiter and CYCLO Drive with Vertical Base”.
The symbols shown below appear in the upper right or left corner of each page to indicate the classication. Please read the
applicable pages.
On
Common pages, symbols identify distinctions between specic specications.
Specications
All specications are
common
Gearmotor
Reducer
(Include with Drive for
servo motor)
Application product
Without brake With brake
Mark
Contents
Common
Introduction: Safety Precautions ……………………………………………………………………………………… 1
Introduction: How to Refer to the Maintenance Manual, Table of Contents ……………………………………… 2
1. Inspection Upon Delivery …………………………………………………………………………………………… 3
2. Storage ……………………………………………………………………………………………………………… 8
3. Transport …………………………………………………………………………………………………………… 9
4. Installation …………………………………………………………………………………………………………… 10
5. Coupling with Other Machines …………………………………………………………………………………… 13
6. Wiring ………………………………………………………………………………………………………………… 15
7. Operation …………………………………………………………………………………………………………… 34
8. Daily Inspection and Maintenance ………………………………………………………………………………… 36
9. Troubleshooting …………………………………………………………………………………………………… 72
10. Construction Drawings …………………………………………………………………………………………… 74
Application Product CYCLO Drive with Torque Limiter
11. Wiring ……………………………………………………………………………………………………………… 82
12. Adjusting Preset Torque …………………………………………………………………………………………… 84
13. Daily Inspection and Maintenance ……………………………………………………………………………… 85
14. Torque Indicator …………………………………………………………………………………………………… 86
15. Construction Drawings …………………………………………………………………………………………… 87
Application Product CYCLO Drive with Vertical Special Base Mount
16. Coupling with Other Machines …………………………………………………………………………………… 92
17. Daily Inspection, Maintenance …………………………………………………………………………………… 94
18. Construction Drawings …………………………………………………………………………………………… 95
Common
19. Warranty …………………………………………………………………………………………………………… 96
Common
Application
Product