To Next PageTo Next Page
Need help?Do you have a question about the Sumitomo CYCLO and is the answer not in the manual?
General| Control Method | PWM (Pulse Width Modulation) |
|---|---|
| Cooling Method | Forced air cooling |
| Protection Features | Overcurrent Protection, Overvoltage Protection, Overtemperature Protection, Short Circuit Protection |
| Operating Temperature | 0°C to 40°C |
| Humidity | 20% to 90% (non-condensing) |
| Dimensions | Varies by model |
| Weight | Varies depending on model (Consult specific datasheet) |
| Storage Temperature | -20°C to +60°C |
Understanding the identification labels on the gearmotor and reducer units.
Specifies environmental conditions and placement requirements for installation.
Details permissible mounting angles for different lubrication types.
Procedures for connecting and aligning external equipment to the drive unit.
Provides tables for various motor types, capacities, and wiring configurations.
Lists critical checks to perform after installation and wiring before initial startup.
Outlines routine checks for noise, vibration, temperature, and oil levels.
Describes standard lubrication methods for different gear unit types.
Illustrates the assembly and components of single and double reduction gear units.
Details wiring procedures for the torque limiter's spring-loaded limit switch.
Explains how to adjust the preset torque for the torque limiter's limit switch.
Covers daily checks specific to the torque limiter unit's functionality.
Explains how to check and interpret the torque indicator readings.
Provides construction diagrams for the torque limiter unit.
Details grease replenishment intervals and quantities for the base unit.
