Appendix F Serial Attached SCSI BIOS Configuration Utility F-15
F.3.7 Device Verify Screen
To access the Device Verify screen, press Enter on the appropriate field on the Device
Properties screen. This screen includes an Elapsed Time and status bar, which begins
incrementing when the operation is started and which shows the current progress of
the operation.
When the Device Verify screen (shown below) appears, press Enter to begin the
verify process. You may press Esc at any time to cancel the verify process.
TABLE F-7
describes the fields of the screen.
TABLE F-6 Device Properties Screen Field Descriptions
Field Description
Device Identifier The ASCII device identifier string extracted from the device’s inquiry
data.
Scan Order The scan order for this device. This is the equivalent of a SCSI ID in
parallel SCSI.
Device Information Indicates whether the device is SAS or SATA.
(SATA is not supported on Sun Fire X4100 or Sun Fire X4200 servers
at this time.)
SAS Address The SAS address of this device.
Serial Number The serial number of this device.
Verify Press Enter to access the Verify All Sectors screen. From this screen
you can start a verification of all sectors on the device (see
Section F.3.7, “Device Verify Screen” on page F-15). If needed, you
can reassign defective Logical Block Addresses (LBAs), as described
in the text following
TABLE F-7.
To Next Page
Loading...
