ENGINE 3-63
• Gradually press out the bearing with the special tool by using
the hand-press.
#
1 Hand-press
2 Crankcase
3 Bearing
NOTE:
Using the hand-press is recommended to remove the crankshaft
journal bearings. However, the crankshaft journal bearings can
be removed by using with the following special tools.
" 09924-84510: Bearing installer set
09910-20116: Conrod holder
09913-60221: Journal bearing remover/installer
• Set the specified crankshaft journal bearings to the special
tool.
#
NOTE:
The upper and lower bearings are same.
The removed bearings must be replaced with new
ones.
* Before setting the bearing, apply enough engine oil
to the special tool and bearings.
* When setting the bearing, align the bearing side with
the engraved line
A and also the bearing end with
the mating surface of the special tool.
PartShark.com
877-999-5686
To Next Page
Loading...
