3-64 ENGINE
• Tighten the special tool bolts to the specified torque.
$ Special tool bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
#
• Set the bearings installed in the special tool to the crankcase
half as shown.
#
NOTE:
Install the bearing from inside to outside of each crankcase
halves.
Before installing the bearings, lightly shave off the
sharp edge part
A of the crankcase chamfer by using
an oilstone and wash the crankcase bore with enough
engine oil.
* Be sure the bearing protruded side
B faces the
crankcase bore.
* Align the bearing/special tool mating surface with
the line
C on the crankcase.
PartShark.com
877-999-5686
To Next Page
Loading...
