PERIODIC MAINTENANCE
2-13
ENGINE OIL REPLACEMENT
Crankcase side
-
-
3
Remove the engine protector cover
ill.
:,
1
Place an oil pan below the drain plug
(21
and
01
on the crank-
-,
case and drain plug
r;5)
on the oil tank. Then drain out the
engine oil
by
removing the engine oil drain plug
(2).
engine oil filler cap
(51,
(61.
*
Reinstall the drain plug
!Zl,
(31,
(9
and gasket. Tighten the
engine oil drain plug
0.
(31
and
(4)
to the specified torque, and
then pour the fresh oil through the oil filler hole. When per-
forming an oil change (without oil filter replacement), the oil
tank will hold about
1.2
L
(1.3
US
qt,
1.1
Imp qt) of oil and the
engine will hold about
0.4
L
(0.4
US
qt.
0.4
imp qt) of oil. Use
of
SFISG
or
SHlSJ
in API with
MA
in
JASO.
Engine oil drain plug
(a,
01:
18
N.m
(1.8
kgf-m,
13.0
lb-ft)
Engine oil tank drain plug
(a!:
12
N.rn
(1.2
kgf-rn,
8.5
lb-ft)
t
-
Make sure that the engine is cooled.
Place the motorcycle on level ground and hold it vertically.
Install the oil filter cap
(51,
la.
.'
'"
9
Start the engine and allow it to run for three minutes at idling
speed.
..
.
i.
i.
&
Q
Turn off the engine and wait about three minutes, and lhen
check the oil level on the dipstick
t?,
The oil level should be
between the
"C'
(low)
(A)
and
"F"
(full)
(a
level lines.
If
the oil
level is lower than the
"L"
:A)
level line, add oil to the
"F"
(0)
level line.
NOTE:
Engine oil expands and oil level increase when
the
engine oil is
hot.
-
..aSI~
-
OIL FILTER REPLACEMENT
(.:
>
~..
Drain the engine oil as described in the engine oil replace-
6.
~-
ri,
ment procedure.
v
,..Q
\
'
\
Remove the oil filter cap
O
and oil filter
(21.
'
?
Replace the oil filter with a
new
one.
To Next Page
Loading...
