7-16
CHASSIS
The standard tire fitted on this vehicle is
AT20x7RIO-:;fiS{ for the front and AT18xlOR8-;':fri.!
for the rear.
The use of tires other than the standard may cause
instability.
It
is highly recommended to use the speci-
fied tire.
Mount the tire on the rim.
NOTE:
L
'
For inspecling the tire. refer to page
2-23.
'
Inspect the valve core, before installation.
*
When installing the front tire, make sure that the arrow
CR
on
2-.
the side wall of the front tire points in the direction
of
rotation.
.
+
When installing the rear tire, make sure that the instruction
j
"SIDE FACING OUTWARDS"
(B!
on the rear tire faces out-
wards.
~---.
r
'
7--
.-
~~
...~
Inflate the tire to seat the tire bead.
Maxlmum tlre bead seat pressure
Front
:
250 kPa (2.5 kgf/cm2,
36
psi)
Rear
:
250 kPa (2.5 kgffcmz,
36
psi)
Place the tire under a protective tire cage or similar
protective covering device before Inflating the tire. To
minimize the possibility of tire damage when seating
the tire bead, never exceed the MAXIMUM
TIRE BEAD
SEAT PRESSURE rating shown on the tire.
To Next Page
Loading...
