7-100
CHASSIS
Tighten the sprocket mounting nuts to the specified torque.
6)
Sprocket mounting nut:
60
N.m
(6.0
kgf-m,
43.5
lb-ft)
NOTE:
.o
,;-,
.
The stamped mark
@!
must
Face to right side of the vehicle.
'fi
Apply grease to the spl~ne of rear axle
Rm-
-.
'--%
"
/&
99000-25010:
SUZUKl SUPER GREASE
"A"
(or equlvalent grease)
Install the sprocket flange
fi
to the axle shaft.
Engage the drive chain
(2)
from the rear sprocket.
Install the washer (thick)
a,
washer (thin)
0,
axle nut
(5)
and
C-ring
(6).
Apply
THREAD
LOCK
SUPER
"1322"
to the thread portion of
the axle nut holder.
a
99000-321 10:
THREAD LOCK SUPER
"1322"
(or equivalent thread lock)
Tighten the axle nut
O
to the specified torque with the special
tool.
Rear axle nut:
240
N.m
(24.0
kgf-m,
173.5
lb-ft)
09940-92460:
Rear axle nut wrench set
NOTE:
When tightening the axle nut with the special tool, the reading
torque on the torque wrench
is smaller than actual torque that is
applied to the axle nut. Therefore convert the tightening torque.
p7-101)
To Next Page
Loading...
