Apply
THREAD
LOCK
SUPER
"1322" to the thread portion of
the axle nut holder.
a
99000-321 10:
THREAD LOCK SUPER
"1322"
(or
equivalent
thread lock)
Tighten the axle lock-nut
c6?
to the specified torque with spe-
cial tool.
Rear axle lock-nut:
240
N-m
(24.0
kgf-m,
173.5
ib-ft)
09940-92460:
Rear axle nut wrench set
NOTE:
When tightening the axle lock-nut with the special tool, the read-
ing torque
on
the torque wrench is smaller than actual torque
that is applied
to the axle lock-nut. Therefore converl the tighten-
ing torque.
(C7below)
Install the rear wheel hubs and wheels.
(W7-13,
14)
After installing the rear axle, adjust the chain slack and park-
ing brake cable.
(W2-19, 26)
Tighten the rear axle housing set nuts in ascending order and
to the specified torque.
Rear axle housing set nut:
28
N.m
(2.8
kgf-rn,
20.0
lb-ft)
REAR AXLE NUT TIGHTENING
TORQUE
Measure the effective length L of the torque wrench.
Calculate the reading torque on the torque wrench by use of the
formula shown below.
L
x
Ts
T=
L
+
LS
T:
Reading torque on the torque wrench
Ts: Specified torque
Ls: 0.060
m
(2.36 in)
Off-set of the specified special tool (09940- 92460)
L: Effective length of the torque wrench
09940-92460:
Rear axle nut wrench set
To Next Page
Loading...
