Chapter 5 Command Reference
Description of SCPI Commands
Operating and Programming Manual 97
SYSTem:KEY? [MIN|MAX]
This query returns the numeric code of the last keypress or minimum-maximum
acceptable range limits.
Does not reflect codes sent by the KEY command.
Response format = <NR1>
SYSTem:PRINt?
This quires prints a status report.
This query or command is identical to the front-panel information print command.
Output format = arbitrary ASCII (several lines of ASCII text).
:REMote
SYSTem:REMote OFF|0|ON|1
This command enables or disables REMOTE operation mode.
The function of this command is ON at *RST.
SYSTem:REMote?
This query returns the state of REMOTE mode.
Response format = <0 or 1>
Returns 1 if REMOTE mode is ON, 0 if REMOTE mode is OFF
SYSTem:SCONfiguration
This command saves the following instrument parameters in nonvolatile memory:
• Serial port: baud rate, data bits, stop bits, and parity
• LCD angle
• Output port frequencies
• Printer report level
The 5071A must be in REMote mode to execute this command.
The function of this command is not affected by *RST.
SYSTem:TIME <hours>,<minutes>,<seconds>
This command is equivalent to ―SOUR:PTIM:TIME‖.
The function of this command is not affected by *RST.
SYSTem:TIME? [MIN|MAX, MIN|MAX, MIN|MAX]
This query returns 24-hour time or minimum-maximum acceptable range limits.
Response format = <NR1, NR1, NR1>, precision = 1 Second.
To Next Page
Loading...
Need help?
General
