Chapter 5 Command Reference
Description of SCPI Commands
Operating and Programming Manual 83
Display Commands
The DISPlay command turns the front-panel LED clock display ON or OFF.
DISPlay:ENABle OFF|0|ON|1
This command enables or disables the LED clock display. The display will
illuminate if the time has been set.
The 5071A must be in REMote mode to execute this command.
REMote mode can be set ON by sending *RST.
The available parameters are:
OFF|0 - turns the display OFF, or
ON|1 - turns the display ON.
:DISPlay:ENABle?
This query returns the LED clock display status as ON or OFF (see above).
The clock display is ON if enabled and time has been set.
Response format <0 or 1>
Returns 1 if clock display is ON, 0 if display clock is OFF.