EasyManuals Logo

Symmetricom 5071A User Manual

Symmetricom 5071A
194 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #82 background imageLoading...
Page #82 background image
Chapter 4 Remote Operation and Programming
Command Types
54 Operating and Programming Manual
If the ―:‖ in front of DIAG is omitted, the instrument assumes that you‘ve sent
SYST:DIAG:CONT:RESET and will generate an error.
*RST Reset Response
The 5071A reset response (Initialization state) is the configuration acquired at
program reset. Table 4-2 summarizes this state. Once a configuration has been
saved, it will persist even if power is removed or until it is reprogrammed (via
SCPI commands or through the front-panel menus).
Table 4-2. *RST Reset Conditions
Subsystem
Command/Parameter
State
DIAGnostic
:LOG:VERBosity
DISable
DISPlay
:ENABle
ON
[SOURce]:PTIMe
:SYNC
OFF
[SOURce]:ROSCillator
:STEer
0.0
SYSTem
:REMote
ON
The IEEE 488.2 *RST command returns the instrument to a specified state
optimized for remote operation. Use *CLS to clear the status registers and the
SCPI error queue.

Table of Contents

Other manuals for Symmetricom 5071A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Symmetricom 5071A and is the answer not in the manual?

Symmetricom 5071A Specifications

General IconGeneral
BrandSymmetricom
Model5071A
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals