Symmetricom 5071A - Contents

Contents
Operating and Programming Manual xi
Setting the Output Port Frequency ......................................17
Setting the 1pps and Clock Outputs ....................................18
To Set the 1pps Outputs................................................................. 18
To Synchronize the 1pps Outputs Using a Time-Interval Counter
........................................................................................................ 18
To Set the Clock.............................................................................. 19
To Turn the Clock Display On or Off ............................................. 20
To Schedule a Leap Second ............................................................ 20
Monitoring Status .................................................................21
To Select Parameters ..................................................................... 21
To Interpret Displayed Results ...................................................... 21
To Print a Status Report ................................................................ 21
Reading and Managing the Event Log ................................22
To Check Log Status ...................................................................... 22
To View Log Entries ....................................................................... 22
To Clear the Log ............................................................................. 22
To Print the Log ............................................................................. 22
Steering the Output Frequency ............................................23
Steering Explained ......................................................................... 23
To Add an Offset ............................................................................. 23
To Check an Offset ......................................................................... 24
To Remove an Offset ...................................................................... 24
Using Utility Features ...........................................................25
To Reset the Continuous Operation Light ..................................... 25
To Reset the Rear-Panel Status Output ........................................ 25
To Display the Firmware Revision or CBT Identification String . 25
Diagnostic Self-Tests ...................................................................... 25
Configuring the 5071A..........................................................26
To Set the Operating Mode ............................................................ 26
To Set the Printer Log Mode .......................................................... 26
To Set Up the Serial Port ............................................................... 27
To Save a Configuration ................................................................. 27
Connecting a Printer.............................................................27
Disabling the Internal Standby Battery ...............................28
Chapter 3 In Case of Difficulty ..........................................29
Chapter 3 Contents .............................................................30
Front-Panel Indicators and Messages ..................................31
Clock Display .................................................................................. 31
Attention Light ............................................................................... 31
Continuous Operation Light .......................................................... 31