Symmetricom 5071A - Setting the Output Port Frequency

Chapter 2 Using the 5071A
Setting the Output Port Frequency
Operating and Programming Manual 17
Setting the Output Port Frequency
Use this procedure to set the output frequencies at rear-panel ports 1 and 2 to
either 5 or 10 MHz.
When the frequency of a port is changed and then returned to the previous
frequency, the original phase is restored.
1 Select the CONFIG menu, then press Enter.
2 Select OUTPUTS, then press Enter.
3 Choose Port 1 or Port 2, then press Inc or Dec to set frequency.
NOTE