Chapter 4 Remote Operation and Programming
Remote-Operation Setup
Operating and Programming Manual 45
The prompt will look either like scpi > or something like E-113> if an error has
occurred. Following the prompt you can type the command you want to send.
For commands that produce a response, the reply will appear on screen. For
example, sending *idn? asks the instrument to identify itself. The transaction
might look something like this:
scpi > *idn?
SYMMETRICOM,5071A,US48051234, 4805
scpi >
After you‘ve selected the communication parameters for the terminal, be sure to
configure the 5071A‘s serial port with the same values, using the CONFIG
menu‘s Serial option.
To Next Page
Loading...
