097-58001-02 Revision C – August 2005 TimeProvider User’s Guide 211
Symbols
<pid>, see password
<sid>, see source ID
<uid>, see user ID
A
access level
changing
94
displaying 93
overview 90
TL1 commands, default 198
ACO, see alarm cutoff
Active LED
147
active, IOC 98
ACT-SWDL command 181
ACT-USER command 90
adding a user 92
address
gate
88
IP 88
alarm
ACO LED
152
clear delay 121
clearing audible 127
codes 164
communication 116
connecting 63
default values 199
displaying current active 123
displaying settings 122
displaying status 125
fault delay 121
IDs 114
LED, on IMC 152
LED, on IOC 147
levels, provisioning 114
local oscillator 117
overview 37
provisioning 114–127
setting PM thresholds 108
strategy, setting 141
system-level 121
alarm cutoff 127
antenna 154
installing 64–70
lightning suppressor, installing 69
location, setting 101
specifications 194
assistance, technical 181
audible alarm, clearing 127
automatic reference switching 102
B
baud rate, setting 86
BesTime
description
39
overview 24
bit position, SSMs 107
block diagram, system 28
block separator, command 80
bridging mode 29
C
cables
antenna to shelf
66
Ethernet 73
lightning suppressor 66
power 55
serial 72
TPIU 70
CANC-USER command 91
CAS inputs 102
CAS outputs 38, 111
case-sensitive commands 80
cautions defined xvi
CCS inputs 102
CCS outputs 111
changing
access level
94
password 93
check list, installation 75
checking comm links, ping 89
circuitry damage, avoiding 146
cleaning the unit 146
clear delay, alarm 121
clearing the audible alarm 127
clock
operating modes
29
overview 23
performance requirements 36
setting the type 98
specifications 189
colon, using in commands 80
comm links, ping command 89
comma, using in commands 80
command
error response
81
general syntax 80
in-process response 81
normal response 81
command separators 80
communication settings, changing 73
Index