Hold 88 FlexSet 120/280 User Guide
Display Message Key LED
To return to the call on multi-hold:
1. Press the lit [HOLD] key (see note 2) or dial #171.
The held calls are returned in “First In/ First Out” order.
CALL HOLD
xxxxx
2. Then either: dial the required held party number
or
Press to scroll through the hold list until the required number is
displayed.
3. Dial activation code
. ANSWER
xxxxx
Notes:
1) This option can only be activated if allowed by system (auto active)
system-wide or the HOLD key is programmed by access code
#171 or followed by activation code
.
2) This option can be activated by the HOLD key if allowed by system
(auto active not defined) system-wide and HOLD key is
programmed only by access code #171.
3) If you do not return to the call on hold within a predetermined
RECALL
xxxxx
FLASHING
amount of time the call will automatically return to you.
4) If your telephone is programmed with Hard Hold the message
CALL ON HOLD will appear after you have placed a call on hold.
When Hard Hold is activated on a call your station will be
considered busy for additional incoming calls. However, outgoing
calls can still be made.
To Next Page
Loading...
