Caller ID Control 41 FlexSet 120/280 User Guide
Display Message Key LED
Caller ID Control #1444
The Caller ID Control feature enables you to allow or restrict presenting of
your telephone number to the called party for external calls. Your telephone is
pre-set in the system to either restrict or display your Caller ID to the called
party. Operating this feature overrides this setting on a per-call basis, if
permitted by COS.
To make a call with a Caller ID Restricted:
(the called station normally displays your ID)
1. Dial #1444 followed by activation code
. ID. ALLOWED
OFF
or
Press
[ID CONTROL],
then
DIAL
ID. RESTRICTED ON
2. Make call as required. OFF
To make a call with Caller ID displayed:
(the called station normally does not display your ID)
1. Dial #1444 followed by cancellation code
. ID. RESTRICTED
ON
or
Press the lit
[ID CONTROL], then DIAL
ID. ALLOWED OFF
2. Make call as required. ON
Notes:
1) When you have a Caller ID programmed key, the LED is lit when
Caller ID Control is restricted from your station.
2) To program a key with the Caller ID Control feature, use feature
code #1444.
To Next Page
Loading...
