Elapsed Time Display 60 FlexSet 120/280 User Guide
Display Message Key LED
Elapsed Time Display #129
This feature enables you to display the elapsed time during an incoming or
outgoing external or network call. When activated from idle, Elapsed Time
automatically displays the duration of a call whenever the call is established.
When activated during a call, Elapsed Time displays the duration of the current
call. The elapsed time is shown in HH:MM:SS format (up to 13 hours)
12:59:59.
To activate Elapsed Time Display from idle (for all calls):
1. Press [ELAPSE] or dial feature code #129 followed by activation code . ELAPSE TIME OFF
OFF
2. Listen for the confirmation tone. ELAPSE TIME ON
ON
To cancel Elapsed Time Display from idle (for all calls):
1. Press [ELAPSE] or dial feature code #129 followed by cancellation code . ELAPSE TIME ON
ON
2. Listen for the confirmation tone. ELAPSE TIME OFF
OFF
During a call:
1. Press the toggle [ELAPSE] to activate or deactivate the Elapsed Time display. hh:mm:ss
2. When the call has ended, the Elapsed Time feature returns to the state it
was set to before the call began.
Note: The system may be programmed with a limit on duration of your
outgoing external calls. Once this limit is reached, the call is
automatically disconnected.
TIME EXPIRED
To Next Page
Loading...
