Stop Dial 175 FlexSet 120/280 User Guide
Display Message Key LED
Stop Dial # or #1300
Stop Dial accelerates sending your call to the external destination or network
number. This feature enables you to tell the system when dialing out on trunks
has been completed. You can send a signal to the system indicating the end of a
stream of dialed digits. In response to your command the system sends your
call immediately towards the destination without waiting interdigit time out.
When you have finished dialing an outside line:
1. Press [#] on the dial pad.
or
Press the
[STOP DIAL] key.
Note: To program a STOP DIAL key, use feature code #1300.
To Next Page
Loading...
