Programming: Boss Group Line Key 144 FlexSet 120/280 User Guide
Display Message Key LED
Programming: Boss Group Line Key #126
PROGRAM LINE KEY
Each FlexSet in a Boss Group can be programmed with line keys. The use of
programmed line keys assists in defining the various ways in which a Boss
Group can answer incoming calls (see page 24) for explanation of Boss
Group).
To program your line keys:
1. Press [PROG] or dial #139. PROGRAM
SELECT BUTTON.
2. Press selected [LINE nn] key for the required line. PROG CONT
KEY CNTNTS ON
3. Dial LINE feature code #126. PROG CONT #126
ENTER LINE # ON
4. Dial line number (00-first line, 01=second line, etc. as defined) LINE nn
ENTER GROUP # ON
5. Dial Boss Group number. PROG CONT
bbbbb
# ON
6. Press selected [LINE nn] key again. PROGRAM END
OFF
7. Press [SPKR] or press and release hookswitch.
Note: Do not perform the above steps if your FlexSet has a button
preprogrammed with a number of the trunk reserved for your Boss
Group. This button will be used as a line key.
n = Line number
b = Boss group number
To Next Page
Loading...
