Receiving Calls 149 FlexSet 120/280 User Guide
Display Message Key LED
Receiving Calls
There are several ways in which you can answer incoming calls:
- Lift the handset
- Press the flashing SPKR button
- Press a flashing key (DSS, Loop, Line, etc.)
xxxxx
CALL
yyyy
Notes:
1) When using the FlexSet 120L, you must use the handset or
headset when speaking.
2) On FlexSet 280D and 280D-Z, calls via ISDN trunks display the
caller’s number or name unless restricted. An ‘I’ before the Caller
I.D. indicates an international call via ISDN.
3) #REST.: Caller ID is restricted by the caller.
zzzz
# REST.
FLASHING
4) #UNAVAIL.: Caller ID is not supported on this route. #UNAVAIL. CALL
yyyy
FLASHING
5) NORMAL CLEAR: The caller has hung up. ON HOOK BY
zzzz
xxxx
NORMAL CLEAR
6) CAUSE #: ISDN protocols define error messages, with codes
indicating the cause of failed connections. The meanings and
ON HOOK BY
zzzz
xxxx
CAUSE#
actions to take are listed in Appendix D - ISDN CAUSE#.
Most messages are for system managers and technicians and will
not be seen during normal operation.
7) See also Waiting Calls Receiving, on page 185,
Second Party’s Speaker St atus, on page 157, and
VIP Tone, on page B-3.
xxxxx = Caller ID, name, or number
yyyy = Your number
zzzz = Trunk number
To Next Page
Loading...
