Programming: Programmable Keys 137 FlexSet 120/280 User Guide
Display Message Key LED
To check key contents:
1. Press [PROG] or dial #139. PROG CONT
KEY CNTNTS
xxxx
2. Press the assigned key (contents are displayed). either KEY CNTNTS
yyyy
CONTINUED
3. Press to check any additional codes on this button. or EXT.
ddddddddddd
4. Press [SPKR] or press and release the hookswitch. then PROGRAM END
To program a key:
1. Press [PROG] or dial #139.
2. Press selected key.
PROGRAM
SELECT BUTTON.
3. Dial the required digits (see page 139) for more details). PROG CONT
KEY CNTNTS ON
4. Press selected key again. PROG CONT
xxxx
ON
5. Press [SPKR] or press and release hookswitch. PROGRAM END
OFF
6. Refer to page 141 for instructions on button labeling.
Repeat the above procedure for each key to be programmed.
To Next Page
Loading...
