Chawter
101
Telecorn
13.
Press
0
to see the DEFINE MODEM FOR HOST ANSWER-
ING MODE screen. (By defining the answer mode of your
modem, you can use the Main Menu function, Host, to let remote-
site terminals access DeskMate.)
14.
Some auto answering modems need a signal to put them in
answer mode. For the Modem
11,
enter Delay:
5,
Send:
**C,
and
Receive:
C.
You are now finished defining the protocol of your auto dialing
modem.
15.
Press
0
to return to the DEFINE MODEM TYPE screen;
then press
0
again to return to the STATUS screen.
Note:
If you are using the Modem
11,
the DTR switch
at the back of the modem must be in the OFF position.
The POWER switch should be
ON,
and the TEST switch
should be OFF. Set the MODE switches to AUTO and
ORIG.
Tandy
1000
85
To Next Page
Loading...
