Chapter
71
Telecom
Press
0
to Send text to the modem. At the prompt,
type the text to send, and press
(ENTERI.
Press
0
to Pause during a command sequence. The
message
PAU
S
E
:
appears on the screen. Type the
number of seconds to pause, and press
IENTER).
Press
0
(WaitNC) to wait for No Carrier detected
before continuing.
W
A
I
T
N
C
is displayed.
Press
0
(WaitC) to wait for a Carrier detected
before continuing. The message,
W
A
I
T
C
,
appears.
Press
0
to set a new Delay time for transmitting
data.
Press
0
to Delete the line under the marker.
Press
0
to Insert a blank line at the current marker
position.
Press
0
to save the completed voice dialing sequence and return
to the Define Modem Type screen.
Comp
Computer Dialing Definition defines the dialing se-
quence your modem uses when executing auto logon
sequences in Terminal. (This is the dialing sequence,
not the logon sequence.) Determine the specific dial-
ing sequence for your modem, then press
(F21
to
display the Computer Dialing Definition functions. The
Computer Dialing functions are the same as those for
Voice Dialing.
Press
0
to save the completed computer dialing sequence and
return to the Status screen.
Answer
Answer Mode Definition defines the answer sequence
your modem uses for answering the remote site when
DeskMate is in the Host mode. Determine the specific
answer sequence for your modem, then press
iF3)
to
display the Answer Mode Definition functions.
Press
0
to Receive text from the remote modem.
The prompt
R
E
C
E
I
V
E
:
appears. Type the text you
expect to receive from the modem, and press
(ENTER).
Tandy
1000
-
53
To Next Page
Loading...
Need help?
General
