4. Defining Filter Slides (infinite® F200 only)
2008-07 Instructions for Use for infinite® 200 No. 30017581 Rev. No. 1.4 61
Note
No special characters (blank, ?, $, %, ., /, etc.) except '_' are allowed for
the filter slide description.
STOP
Caution
The filter slide description is part of the G-Factor key value.
If manually entered, avoid using the same description for
the different filter slides.
Position 1 - 4: Filter definition editor for the filters (filter pairs) on positions 1, 2, 3
and 4.
Select the appropriate filter position and enter the new wavelength, bandwidth
and measurement mode for each new filter:
Measurement Mode: chose from the dropdown list ‘FI’ for fluorescence intensity,
‘ABS’ for absorbance, ‘FP’ for fluorescence polarization and ‘Empty’ for filter-free
positions
To Next Page
Loading...
