Then adjust the drain valve to the toilet electronics:
on newer cisterns installed after mid/end of , the red
pull rod of the valve (A) must be replaced by a black one
(see figure above).
Insert the (new) splash guard for the electronics with the
actuation motor. The activation hooks must fit correctly in
the drain valve's drawbar eyelets. Tighten the splash guard
clamping screws.
Mount the two attachment rods – distance to wall surface
= mm.
Mount the support frame.
Break o the actuating rods according to the thickness of
the wall structure. Screw in both actuating rods – distance
to front edge of support frame = mm.
-
Flush plates
To Next Page
Loading...
