Toilet electronics, remote release, 6 V battery
The radio signal sent when the radio switch is activated is
received by a radio receiver. This receiving unit operates
the power circuit to trigger the actuation motor. Power is
supplied via four batteries enclosed in waterproof housing
in the cistern.
Installing the toilet electronics, remote release,
6 V battery
To install the battery version for the toilet electronics
remote release, proceed as follows:
First remove the splash guard with the flush plate – this
will no longer be required. Open the corner valve and su-
ciently flush out the pipe.
Turn the corner valve to close it again and connect the
reinforced hose to the filling valve. If you wish to fill the
cistern with water (e.g. for the initial operation), you must
open the corner valve again.
Then adjust the drain valve to the toilet electronics:
on newer cisterns installed after mid/end of , the red
pull rod of the valve must be replaced by a black one (fig.
– A).
Place the four batteries in the housing and hang the water-
proof battery compartment on the reinforced hose in the
cistern.
-
Flush plates
To Next Page
Loading...
