TECE Lux Mini - Toilet Electronics, Cable-Connected Remote Release, 12 V Mains; Installing the Toilet Electronics, Cable-Connected Remote Release, 12 V Mains

Then, connect the electronics first to the motor (grey plug)
and then also to the batteries (black plug). If the installation
is correct, the motor will be activated once for checking
purposes.
Now check that the electronics are functioning correctly: to
do this, press the button again to activate the motor (once).
Mount the flush plate support frame and install the
electronics and the batteries in a suitable location (e.g.
between the support frame and the flush plate). Finally,
install the flush plate.
Toilet electronics, cable-connected remote
release, 12 V mains
When the electric circuit to the switch on the safety sup-
port arm is closed, the flush is activated. In addition to the
electrical supply, the switch on the safety support arm and
the actuation motor, an additional electronic component
must also be installed between the dierent components.
To connect the  V mains variant, the power supply must
be transformed to  V DC by a TECE transformer (order
transformer separately: order no. ).
Installing the toilet electronics, cable-con-
nected remote release, 12 V mains
To start with, the toilet electronics with cable-connected
remote release are installed in the same way as the
remote release:
Open the splash guard, suciently flush out the pipe, and
adjust the drain valve (see also: Installing the toilet elec-
tronics, remote release,  V battery).
The subsequent work steps dier depending on the
installed toilet module: Either a TECE Geronto module with
conduits for cabling and an installation box for housing the
electronics, or a dierent TECE module without conduits,
will be installed.
-
Flush plates