TECE Lux Mini - TECEplanus Remote Release Electronics; TECEplanus Radio Switch and Transmitter Installation

TECEplanus electronics, remote release
Electronic flush systems are also available when using
safety arm supports. It is possible to install a radio switch
for electrical actuation on the safety arm support. It is also
possible to use several radio switches with one receiver.
Power options for toilet electronics with remote release
• Mains variant:
The TECE transformer (order no. , order sepa-
rately) transforms  V AC to  V DC.
• Battery operation:
 x LR mono cells – 6 V
Based on a service life of two years, the battery lasts for
• , flushes or
• approx.  flushes/day.
Observe the following:
A transformer must be used for the  V mains variant. A
suitable place for this (flush-mounted socket or other) must
be provided for the purpose as it must not be positioned
next to the flush plate under any circumstances.
A flush plate is not included in the scope of supply. Any
single-flush system can be used with the remote release,
and all two-flush systems are possible too (e.g. TECE-
loop, TECEsquare). However, the largest flush volume will
only ever be activated, even if both actuating rods were
installed during installation.
TECEplanus radio switch
The TECEplanus radio switch (order no. ) can be
retrofitted for most safety arm supports, and is coordinated
with the TECEplanus toilet remote release.
TECEplanus radio switch
Initial operation
Before installing the radio transmitter on the safety arm
support, the supplied batteries must be installed:
• Unscrew the screw on the back of the housing and open
the cover. Insert both batteries as indicated on the hous-
ing.
• You can only set the volume of the “beep” for the acous-
tic flush acknowledgement when the housing is open.
We recommend the factory setting: full volume.
• To lower the volume, turn the controller to the left. Turn
the controller to the right to increase the volume.
Volume controller
Now close the housing tightly again.
• Make sure that you fit the housing cover correctly: the
cover features a sealing ring which prevents water from
penetrating inside.
• When screwing on the housing cover, also make sure
that the sealing ring fits precisely around the locking
screw.
TECE flush plates – TECEplanus electronics, remote release
-
Flush plates