The subsequent work steps dier depending on the
installed toilet module: Either a TECE Geronto module with
conduits for cabling and an installation box for housing the
electronics, or a dierent TECE module without conduits,
will be installed.
... Geronto module with conduits
Open the cistern cover and remove it with the installation
box. Guide the battery connections and actuation motor
from beneath through the openings in the bottom of the
box.
Connect the radio electronics first to the motor (black plug)
and then also to the batteries (grey plug). If the installation
is correct, the motor will be activated once for checking
purposes.
After installing the radio receiver, it must be coordinated
with the signal from the switch on the safety arm support.
To do this, press the blue button on the receiver electron-
ics, the LED next to it will now briefly light up once (fig.
). After this, the receiver is ready for reception for one
minute. During this time, press the button on the safety
arm support once to establish a connection with the
receiver electronics. If successfully connected, after acti-
vating the switch, the control LED on the receiving unit will
flash three times.
TECE flush plates – TECEplanus electronics, remote release
-
Flush plates
To Next Page
Loading...
