Technogym BIOSTRENGTH LINE - Disassembling the Bars

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.106
7.3.22. DISASSEMBLING THE BARS
Figure 7.3.22-1
Follow the steps described in paragraph 7.3.9.
“Disassembling the weight stack cover”.
For each of the 2 counter-weight vibration bars:
1. Unscrew the 2 dowels a, using a 4-gauge
hexagonal T-wrench.
Hold the BAR up before unscrewing the
last screw .
2. Remove the BAR by sliding it upward.
To reassemble the BARS, follow the above steps
in reverse order