Technogym BIOSTRENGTH LINE - Number of Relay Switching Cycles to Move the Seat Motor Downward; Number of Fail Signals Produced by the Seat Motor Interface Board; Number of Solenoid Relay Switching Cycles; Machine Running Time

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 9.20
S E A T R E L A Y U P
C Y C L E S : X X X X X
Press ENTER to continue.
9.5.9. NUMBER OF RELAY SWITCHING CYCLES TO MOVE THE SEAT MOTOR
DOWNWARD
This parameter does not appear for Abdominal Crunch and Lower Back.
The number of times the seat motor interface board relays have switched in order to move the motor
downward.
S E A T R E L A Y D O W N
C Y C L E S : X X X X X
Press ENTER to continue.
9.5.10. NUMBER OF FAIL SIGNALS PRODUCED BY THE SEAT MOTOR INTERFACE
BOARD
This parameter does not appear for Abdominal Crunch and Lower Back.
The number of fails signals produced by the seat motor interface board.
T O T A L F A I L S E A T
N : X
Press ENTER to continue.
9.5.11. NUMBER OF SOLENOID RELAY SWITCHING CYCLES
The number of times the solenoid interface board relays have switched in order to activate the
solenoid.
S O L E N O I D R E L A Y
C Y C L E S : X X X X X
Press ENTER to continue.
9.5.12. MACHINE RUNNING TIME
This is the total number of hours for which the machine has been powered.
M A C HI N E ON
H O U R S X X : X X
Press ENTER to continue.