Technogym BIOSTRENGTH LINE - Disassembling the Encoder

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.247
7.6.32. DISASSEMBLING THE ENCODER
Figure 7.6.32-1
Follow the steps described in paragraph 7.6.30.
“Disassembling the columns” limited solely to
the right-hand column.
1. Release the slot a of the ENCODER wire
from the hook.
Figure 7.6.32-2
2. Disconnect the connector b of the
ENCODER cable.
3. Cut the clamp c.
4. Disconnect the connector d from the encoder
cable.
5. Unscrew the 3 screws e using a 3-gauge
hexagonal T-wrench.
6. Remove the ENCODER.
Hold the ENCODER up before
unscrewing the last screw.
To replace the ENCODER, follow the above
steps in reverse order.