Technogym BIOSTRENGTH LINE - Disassembling the Lever Cable

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.239
7.6.24. DISASSEMBLING THE LEVER CABLE
Figure 7.6.24-1
Follow the steps described in paragraphs 7.6.14.
“Disassembling the rear guard” and 7.6.23.
“Disassembling the rear lever guard”.
For each lever group:
1. Loosen the 2 dowels a, using a 4-gauge
hexagonal T-wrench.
2. Remove the LEVER CABLE with the aid of
a pair of pliers.
3. Remove the LEVER CABLE by sliding it out
of the pulleys.
To reassemble the LEVER CABLE, follow the
above steps in reverse order.
When the operation is complete, adjust
the tension of the LEVER CABLE and
the lever position as described in
paragraphs 8.6. and 8.2. .