BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.241
7.6.26. DISASSEMBLING THE LEVERS
Figure 7.6.26-1
1. Shut off the equipment and unplug the power
cord from the wall socket.
Working first on the LEFT LEVER and then on
the RIGHT LEVER:
2. Unscrew the cap a using a 6-gauge hexagonal
T-wrench.
Figure 7.6.26-2
3. Unscrew the screw b using a 17-gauge tube
wrench.
4. Remove the washer.
5. Use the extractor provided in the machine
service box to remove the LEVER,
tightening the extractor screw using a 24-
gauge wrench.
To reassemble the LEVERS, working first on the
RIGHT LEVER and then on the LEFT LEVER:
1. Insert the lever on the shaft, making sure that
the key is inserted in the slot provided on the
LEVER.
2. Push the LEVER all the way down with a
rubber hammer.
3. Insert and tighten the screws removed
previously.
When the operation is complete, adjust
the position of the levers as described in
paragraph 8.2. .
To Next Page