BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 8.19
8.2.9. LEG PRESS
Figure 8.2.9-1
1. The cam group must be mounted so that it
respects the measurements shown in the
drawing.
2. Adjust the starting position of the mats so
that:
• They have the maximum stroke;
• The block of mats may easily be moved
to perform the exercise with the mats
connected or disconnected.
3. Cut the weight stack cable (5480 mm) and
the lever cable (4330 mm) to size.
4. Connect and power all cables.
Adjust the doubling cable, adapting its
size, so that the cables have the proper
tension.
The weight stack cable must detach
from the cam at the notch on the cam
itself.
To Next Page