Technogym BIOSTRENGTH LINE - Disassembling the Starter Plate and Fuses

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.168
7.4.37. DISASSEMBLING THE STARTER PLATE AND FUSES
Figure 7.4.37-1
Follow the steps described in paragraph 7.4.23.
“Disassembling the seat guard”.
1. Loosen the 2 screws a using a 5-gauge
hexagonal T-wrench.
2. Remove the STARTING PLATE AND
FUSES, being careful not to tear the cables.
3. The PLATE is thus available for any
necessary operations.
To replace the STARTING PLATE AND
FUSES, follow the above steps in reverse order.