BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.376
7.9.29. DISASSEMBLING THE ELECTRONIC COMPONENTS OF THE SECONDARY
ELECTRICAL BOX
Figure 7.9.29-1
Follow the steps described in paragraph 7.9.28.
“Disassembling the secondary electrical box”.
With the electrical box resting on a bench:
To disassemble the IMS LPO BOARD a:
1. Lift the board.
2. Disconnect the 3 connectors.
3. Disconnect the 4 plastic coupling elements.
4. Remove the card.
To disassemble the TRANSFORMER b:
1. Disconnect the secondary cables from the
board connectors.
2. Unsolder the primary cables from the selector
switch.
3. Unscrew the holding screw a using an 8-
gauge wrench.
4. Remove the transformer.
To disassemble the 110/220 SELECTOR
SWITCH c:
1. Unsolder the cables.
2. Unscrew the holding nut.
3. Remove the selector switch.
To disassemble the RECTIFIER d:
1. Disconnect the cables.
2. Unscrew the holding nut.
3. Remove the rectifier.
To reassemble the ELECTRONIC
COMPONENTS OF THE SECONDARY
ELECTRICAL BOX, follow the above steps in
reverse order.
To Next Page