BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.238
7.6.23. DISASSEMBLING THE REAR LEVER GUARD
Figure 7.6.23-1
1. Shut off the equipment and unplug the power
cord from the wall socket.
For each side of the weight stack:
2. Remove the cap a of the GUARD using a
small flat screwdriver.
3. Unscrew the 5 screws b, one of which is
under the cap a, using a medium-sized
Philips screwdriver.
4. Slide the REAR LEVER GUARD out.
To reassemble the REAR LEVER GUARDS,
follow the above steps in reverse order.
To Next Page