Technogym BIOSTRENGTH LINE - Disassembling the Additional Weight

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.267
7.7.11. DISASSEMBLING THE ADDITIONAL WEIGHT
Figure 7.7.11-1
Follow the steps described in paragraph 7.7.10.
“Disassembling the weight stack cover”.
1. Remove the ADDITIONAL WEIGHT a by
sliding it upward.
Press the solenoid pin inward so that it
does not interfere with the additional
weight.
To reassemble the ADDITIONAL WEIGHT,
follow the above steps in reverse order.