BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 8.22
8.5. ADJUSTING THE PRESTART CABLE TENSION
8.5.1. ADJUSTING THE PRIMARY PRESTART CABLE TENSION
This operation holds for the Vertical Traction, Shoulder Press and Chest Press.
Figure 8.5.1-1
1. Make sure that the easy start lever is properly
positioned.
2. Adjust the easy start cable tension by means
of the nut a, holding the screw b in place so
that the cable is taut.
The length of the primary easy start cable is shown in the table below:
Machine Length
(mm)
Abdominal Crunch -
Lower Back -
Leg Extension -
Leg Curl -
Vertical Traction 2610
Shoulder Press 2520
Chest Press 1180
Rowing Torso -
Leg Press -
To Next Page
Loading...
