BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.108
7.3.24. DISASSEMBLING THE SEAT MOTOR
Figure 7.3.24-1
Carry out these operations with the
machine powered and switched on.
1. Position the seat all the way forward 0.
2. Unscrew the 2 screws b using a 4-gauge
hexagonal T-wrench for each side of the
motor guard a.
3. Remove the motor guard.
Figure 7.3.24-2
4. Use a medium-sized Philips screwdriver to
unscrew the 5 screws c.
5. Remove the backrest guard .
6. Unscrew the screw d and the nut e using 2
17-gauge wrenches.
7. Remove the motor from its housing.
8. Move the seat back.
Continued on next page →
To Next Page