BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.313
7.8.12. DISASSEMBLING THE ENCODER
Figure 7.8.12-1
Follow the steps described in paragraph 7.8.7.
“Disassembling the rear plexiglas weight stack
guard”.
1. Release the slot a of the ENCODER wire
from the hook.
Figure 7.8.12-2
2. Disconnect the connector b of the
ENCODER cable.
3. Use a 3-gauge hexagonal T-wrench to
unscrew the 4 screws c.
4. Remove the ENCODER.
Hold the ENCODER up before
unscrewing the last screw.
To replace the ENCODER, follow the above
steps in reverse order.
To Next Page