BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.181
7.5.11. DISASSEMBLING THE UPRIGHT GUARD
Figure 7.5.11-1
Follow the steps described in paragraphs 7.5.7.
“Removing the seat” and 7.5.8. “Disassembling
the front guard”.
For each side:
1. Remove the 2 caps a of the GUARD using a
small flat screwdriver.
2. Unscrew the 2 screws under the 2 caps a
using a medium-sized Philips screwdriver.
3. Widening the sides slightly, remove the
UPRIGHT GUARD by sliding it upward.
To reassemble the UPRIGHT GUARD, follow
the above steps in reverse order.
To Next Page