BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 9.5
4 – 5 23
5 – 6 24
6 – 7 23
7 – 8 24
8 – 9 23
9 – 10 23
10 – 11 23
11 – 12 23
12 – 13 23
13 – 14 22
14 – 15 23
15 – 16 23
16 – 17 23
17 – 18 23
18 – 19 23
19 – 20 23
20 – 21 23
21 – 22 23
22 – 23 40
Enter the value, then press “Enter” to continue or “Clear” to abort. Move on to the next parameter
when all distances have been configured.
9.2.7. NUMBER OF PULSES FOR SEAT SELECTION
This parameter does not appear for Abdominal Crunch and Lower Back.
This option allows you to set the number of pulses produced by the encoder associated with the seat
motor to complete the entire seat stroke:
T O T A L R A N G E S E A T
P U L S E S = XX X
This value depends on the type of motor used and the transmission ratios of the
mechanics used in order to make the selection. Thus, if not otherwise advised, maintain
the value as specified in the table below:
Machine Pulses
Leg Extension 355
Leg Curl 355
Vertical Traction 355
Shoulder Press 355
Chest Press 355
Rowing Torso 355
Leg Press 430
Enter the value, then press “Enter” to continue or “Clear” to abort.
To Next Page
Loading...
