Technogym D93TNL - Turning the Product on and off

4.6 TURNING THE PRODUCT ON AND OFF
Press the switch underneath the display to turn the equipment on and o󰀨. The product must be
connected to the mains power supply.
Turn the product o󰀨, after exercising, only when it is in stand-by
When the display is o󰀨, the LED (T) lights up.
When the display is on and the product is being used, the LED (T) is o󰀨.
When the display is on but the product is not being used, the LED (T) will be ashing.
If you do not expect to use the product for some time, turn it o󰀨 at the switch and take the power
plug out of the wall socket.
The switch only turns the display on/o󰀨 but does not completely isolate the product from the mains
voltage. Take the power plug out of the socket to isolate the product.
Fig. 16
TECHNOGYM BIKE LIVE Technical Service Guide
Rev. 2.0
- 31 -TSG-00187-EN - Uncontrolled copy if printed