Technogym D93TNL - Tightening Torques- Greases - Adhesives & Sealants; Pivoting Display Support

The belt tension must be measured in the point shown by the arrow in the gure below.
Fig. 59
9.3 TIGHTENING TORQUES- GREASES - ADHESIVES &
SEALANTS
9.3.1 PIVOTING DISPLAY SUPPORT
_Apply a white grease on the friction rings.
Fig. 60
_Tighten the screws [1] with a torque wrench set to 16 Nm [12 lbf-ft] and the screw [2] with a torque
wrench set to 3,5 Nm [2,6 lbf-ft].
TECHNOGYM BIKE LIVE Technical Service Guide
Rev. 2.0
- 95 -TSG-00187-EN - Uncontrolled copy if printed